The AEB4-I from RME is an expansion daughter board that adds four balanced analog inputs to any ADAT capable RME system. The later include the DIGI96/8 Series, the Hammerfall Series and the HDSP 9652.
The card provides either +4dBu or -10dBV input level adjustment along with specifications that include a 107dBA signal to noise ratio and the highest suppression of PC-noise.
The AEB4-I offers four 1/4" TRS phone connectors and installation is easy and convenient using the supplied bracket. A card slot is not required.
Note: Multiface and Digiface use the Hammerfall DSP PCI card. This card has no internal inputs or outputs and therefore cannot utilize any expansion boards
Specifications:
Connectivity:
DIGI96/8:
A single AEBx-I and one AEBx-O can be connected and operated simultaneously
Hammerfall or Hammerfall Light:
One AEBx-I and two AEBx-O can be connected and operated simultaneously. Requires board revision 1.5 or higher
HDSP 9652:
Two AEBx-I and two AEBx-O can be connected and operated simultaneously
Converters: 24-bit
Sample Rates: 32kHz to 48kHz
Analog Inputs: 4 x 1/4" TRS phone, servo balanced
Analog Outputs: Not applicable
Digital Inputs: No
Digital Outputs: No
MIDI In/Out: No
Sync In/Out: No
Headphone Output: No
THD + N: -95dB (0.0017 %)
Dynamic Range: 104dB, RMS unweighted, 107dBA
Frequency Response: 10Hz to 21kHz, -0.1dB
System Requirements: As per host system
Specialties: No slot needed on the motherboard
