Switchable Input Attenuator with 20, 30 or 40dB of Attenuation


Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
ONLINE
Ships today
AUCKLAND
2-3 days
WELLINGTON
In Stock
North Island
$3.72
South Island
$3.72

This ATT-448 from Hosa is a switchable input attenuator for stepping-down an input level to a mixer when that level is too high. For instance, a hot microphone in front of a loud source will "peg the meters" at the board and cause audio distortion.

The ATT-448 attenuator is placed in-line between the microphone and the board and the appropriate amount of attenuation switched in. The choices are 20, 30, or 40dB of signal reduction, for a wide range of uses on stage and in the studio.

The unit accepts the appropriate male and female XLR connector.

  • Provides 20dB, 30dB or 40dB of microphone attenuation
  • For use with all low-impedance and phanton-powered condenser microphones
  • XLR input and output
  • Full magnetic shield case
Product:
Hosa ATT-448 Mic Input Attenuator
Manufacturer:
Hosa Tech
Model:
ATT448
SKU:
ATT-448
RM Product #:
4438
Cable Connector:
XLR (3-Pin) Male
Cable Connector:
XLR (3-Pin) Female