Korg ARP Odyssey FSQ Rev3 Full-Sized Analog Synthesizer with SQ-1 Step Sequencer
Features
- Limited Edition Full-Sized Bundle.
- Recreation of Classic ARP Odyssey.
- Reproduced Exact Circuitry of Original.
- Filter Revisions: Type I, II, III.
- Two VCOs + VCA Overdrive.
Description
The Korg ARP Odyssey FSQ Rev3 Full-Sized Analog Synthesizer with SQ-1 Step Sequencer is the re-creation of the classic analogue synthesiser originally produced in the 1970s and highly regarded for its sharp, penetrating sound and rich range of tonal variations. This full-sized recreation features the original circuitry with some updated features including MIDI and USB.
The synth offers a 37-note full-sized keyboard with monophonic or duophonic operation. The oscillator section includes two VCOs with sawtooth, square, and pulse waveforms. Additionally, all three revisions of the filter are immediately accessible via switch and further broaden the tonal palette. Type I (Rev. 1) is a 12 dB/Oct circuit, while Type II and III (Rev. 2 & 3) are 24 dB/Oct, and each type adds distinct flavours and colours to the sound. Both portamento circuits (Rev.1 & 2/3) are available as well, while a drive circuit has been added to the VCA, producing distortion and generating a rough and raw sound. All sliders have been updated and are smoother than the original, making the synth uncompromisingly playable. A variety of functions and modulation possibilities are provided by oscillator sync, pulse width modulation, sample & hold, a high-pass filter, two types of envelope generators, an LFO, and pitch bend via the proportional pitch controls (PPC).
The SQ-1 Step Sequencer is inspired by the original SQ-10 step sequencer, which provides two CV/GATE out channels as well as MIDI OUT, USB MIDI, and more. The unit offers two channels (A and B) of an 8-step sequencer that can operate consecutively or in a variety of other modes. You can run A and B following each other to function as a 16-step sequencer, ignore the order to make the steps play randomly, or use A and B to control different parameters as they run in parallel. The variety of selectable modes enables everything from simple sequences to complex changes. The Korg ARP Odyssey FSQ Rev3 includes the SQ-1 step sequencer, a power adapter, a 1/4" cable, and an 1/8" cable.
Key Features:
Arp Odyssey FS
- Faithful recreation of the original, full-sized Arp Odyssey
- 37-note full-sized keyboard
- Monophonic or duophonic operation
- Two VCOs featuring Sawtooth, Square, and Pulse waveforms
- VCF switchable between rev. I, II, and III
- VCA with overdrive
- ADSR envelope generator
- AR envelope generator
- LFO
- Noise generator
- Portamento
- Ring modulator
- Sample & hold
- External audio input
- USB MIDI
- CV/Gate I/O
- Extended body protects keys
- Phone and mini-phone cables included
SQ-1 Step Sequencer
- Connectors
- Provides two CV/GATE OUT channels, a standard MIDI OUT, USB MIDI, littleBits out (to connect to littleBits synth kit), as well as SYNC IN/OUT channel to connect to the Volca series or a Monotribe
- Versatile Sequencer Modes
- Provides two channels (A and B) of an 8-step sequencer that can operate consecutively or be used in a variety of other modes such as in 16-step sequencer mode, ignoring the order to play randomly, or with different control parameters for A and B run in parallel
- Volca Style Step Buttons
- Features a 2 x 8 step button grid that allows you to turn notes on/off or use the MODE button to switch their function for powerful performance possibilities
- Active Step
- Skip steps mid-way through a sequence
- Step Jump
- Instantly play just the step that you press to produce irregular rhythms or effects that are reminiscent of short loops
- Slide
- Produces an effect in which steps are connected smoothly
Specifications
Instrument | |
Keyboard | 37-note (Standard, full-sized keys, no velocity sensitivity, no aftertouch) |
Polyphony | Maximum Polyphony: 2 voices for duophonic; normally monophonic |
Controllers | Transpose Positions: 2 octaves down, normal, 2 octaves up Proportional Pitch Control Pitch Down Pad (b): about -2 / 3 octave Modulation Pad (-) Pitch Up Pad (#): about +2 / 3 octave |
Noise Generator | Noise Spectrum Types: White and pink |
Portamento | Maximum Speed: About 0.01 ms/oct Minimum Speed: About 1.5 seconds/oct |
VCO | Voltage-Controlled Oscillator Waveforms: Sawtooth, square, pulse (dynamic pulse) Frequency Range: VCO-1 in Low Frequency Mode: 0.2 to 20 Hz VCO-1 and VCO-2 (Audio Range): About 20 Hz to 20 kHz Warm Up Drift: 1/30 semitone from turn on max Pulse Width: 50 to 5% Pulse Width Modulation: ADSR: +45% LFO: +15% Voltage Controlled Response: 1 V/oct Maximum Frequency Shifts: LFO Sinae Wave: +1/2 oct. LFO Square Wave: +1.5 oct. ADSR: +9 oct. S/H: +2 oct. (*VCO-1 is low note priority, VCO-2 is high note priority) |
VCF | Voltage Controlled Filter Types: Low pass (I: 12 dB/oct., II III: 24 dB/oct.) Frequency Range: 16 Hz to 16 kHz Maximum Usable Q: 30 Resonance: 1/2 - self oscillate Voltage Controlled Response: C3 key (left edge) 0 V C6 key (right edge) 3 V |
VCA | Voltage Controlled Amplifier Dynamic Range: 80 dB |
Ring Modulator | Type: Digital Input Signal: VCO-1, VCO-2 (square wave) |
Sample & Hold | Command Sources: Keyboard or LFO trigger Sampled Signals: VCO-1 sawtooth wave and square wave VCO-2 square wave and pink noise |
Envelope Generators | ADSR Envelope Generator Attack Time: 5 msec. to 5 sec. Decay Time: 10 msec. to 8 sec. Sustain Level: 0 to 100% or Peak Release Time: 15 ms to 10 seconds AR Envelope Generator Attack Time: 5 ms to 5 seconds Release Time: 10 ms to 8 seconds |
Control Input | Control Input Jacks Pedal: 1/4" / 6.3 mm monaural phone jack Portamento Foot Switch: 1/4" / 6.3 mm monaural phone jack |
Audio Output | Low Connector: 1/4" / 6.3 mm monaural phone jack Maximum Output Level: -20 dBu @ 10 kOhms load Output Impedance: 10 kOhms High Connector: XLR connector Maximum Output Level: +4 dBu @ 1 kOhm load Output Impedance: 330 ohms Headphones Connector: 1/4" / 6.3 mm stereo phone jack Maximum Output Level: 50 mW + 50 mW @ 33 ohms load Output Impedance: 10 ohms (Controllable by volume knob) |
External Analogue Audio Input | Connector: 1/4" / 6.3 mm monaural phone jack Maximum Input Level: -10 dBu Input Impedance: 22 kOhms |
MIDI | In |
USB | Type B |
CV In/Out Controls | Keyboard CV (In/Out): 1 V/octave Connector: 1/8" / 3.5 mm monaural phone jack |
Gate | Gate In: +3 V (minimum) Gate Out: +10 V, key down; 0 V all keys up Connector: 1/8" / 3.5 mm monaural phone jack |
TRIG Connector | Trig In: +3 V pulse min., 10 μsec duration minimum Trig Out: +10 V pulse on key depression, 10 μsec duration Connector: 1/8" / 3.5 mm monaural phone jack |
Power | Power Supply: AC adapter jack (12 VDC) Power Consumption: 7.1 W |
Dimensions (W x D x H) | 23.0 x 18.3 x 6.4" / 585 x 466 x 163 mm |
Weight | 16.1 lb / 7.3 kg |
Step Sequencer | |
Modes | Sequencer Modes Alternate Order Parallel Turn Parallel Order CV/Duty CV/Slide CV/Duty Random Random Step Modes Gate On/Off Active Step Slide Step Jump |
Resolution | Quarter notes Eighth notes Sixteenth notes |
CV In/Out Controls | Out Pitch: Linear, Minor, Major, Chromatic Out Voltage: 1 V, 2 V, 5 V (Oct), 8 V (HZ/V) |
Gate | Output Polarity: +(positive polarity), -(negative polarity) |
Sync | In/Out Polarity: +(rise), -(fall) |
Connectors | LittleBits out jack (mini monoaural phone jack) OUT (MIDI OUT) jack (mini stereo phone jack) CV-A OUT-Gate jack (mini monaural phone jack, CV OUT: Output level 1 V, 2 V, 5 V, 8 (Hz/V), GATE OUT: output level 10 V) CV-B OUT-GATE jack (mini monaural phone jack, CV OUT: Output Level 1 V, 2 V, 5 V, 8 (Hz/V), GATE OUT: Output level 10 V IN-SYNC-OUT jack (mini monaural phone jack, SYNC IN: Max input level 20 V, SYNC OUT: Output level 5 V) USB jack (type B, USB MIDI) |
Power Supply | 2 x AA batteries (alkaline recommended) or USB power |
Battery Life | Approximately 5 hours (when using alkaline batteries) |
Dimensions (W x D x H) | 7.6 x 3.3 x 2.5" / 9.3 x 8.4 x 6.3 cm |
Weight | 1.4 lb / 0.6 kg |
In The Box
- Korg ARP Odyssey FSQ Rev3 Full-Sized Analogue Synthesiser with SQ-1 Step Sequencer.
- AC Adapter.
- Power Cord.
- 1/4" / 6.3 mm Cable.
- 1/8" / 3.5 mm Cable.
- Korg SQ-1 Step Sequencer.
Reviews
(no ratings yet)Give it a quick rating:
Thanks for your rating!
Write a review
Details
- Product: Korg ARP Odyssey FSQ Rev3 Full-Sized Analog Synthesizer with SQ-1 Step Sequencer
- Manufacturer: Korg
- Model: KOR-ODYSSEY-FSQ3
- SKU: KOR-ODYSSEY-FSQ3
- RM Product #: 65144