RME TEB has been discontinued, here are some related products you might like:

8 channel TDIF expansion board for DIGI96 and Hammerfall series


Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
Email me when stock arrives
North Island
$6.62
South Island
$6.62

The TEB (TDIF Expansion Board) adds an eight-channel TDIF interface to all ADAT-capable RME cards. Special features include manual choice of clock reference, status LEDs and a word clock output.

The board is designed for maximum flexibility. Used with the Hammerfall series and the HDSP 9652, it can even be used at sample rates of 88.2kHz and 96kHz. However, at these higher rates only four channels are available.

Installation is simple using the supplied bracket and no PCI slot on the motherboard is needed. The integrated Clock Select Switch sets the TDIF reference clock, thus avoids any clocking problems even with "problematic" TDIF devices.

Specifications:

Connectivity:
DIGI96/8:
A single TEB can be connected
Hammerfall or Hammerfall Light:
One TEB can be connected and operated. Additionally one AEBx-O can be used simultaneously. Requires board revision 1.5 or higher
HDSP 9652:
Two TEBs can be connected and operated simultaneously. One TEB can be used together with either one AEBx-I or AEBx-O

TDIF Port: D-sub 25 pin
Supported sample rates: 44.1 kHz, 48 kHz, varispeed (33 - 57 kHz)
Double Line Mode: 4 channels at 88.2 kHz and 96 kHz (not with DIGI96 series)
Word Clock Output: BNC, low-impedance driver stage, 4 Vpp into 75 Ohms, short-circuit-proof
Sync Source: ADAT (host/card) or TDIF
Power supply: 3.5" floppy connector, 5 V DC, 100 mA
Standard bracket, board dimensions: 75 x 95 mm,

2 internal cable 2-pin, 1 internal cable 3-pin, 1 power adapter cable 5 1/4" to 2 x 3.5" included

Specialties: No slot needed on the motherboard

Links:

Product Manual
Manufacturers website

Product:
RME TEB
Manufacturer:
RME
Model:
RME-TEB-TDIF
SKU:
RME-TEB-TDIF
RM Product #:
3363