(no ratings yet) Thanks for your rating!
The Rycote TAC!T- Ultra Flexible Star Quad XLR-3F to XLR-3M Mogami Cable with Integrated Third Order 18 dB/Octave HPF (18") is designed to filter out infrasonics and low frequency noise below 60 Hz such as from wind, surface vibrations, and handling noise that could otherwise overload your microphone. The filter is built into a Neutrik XX-series XLR connector and requires a portion of a mixer's or preamp's phantom power to operate. The filter is symmetrically balanced so it can then pass phantom power to the condenser microphone while retaining a balanced signal. Because it requires the microphone to draw phantom power through the circuit, the filter will not work with dynamic microphones and may slightly reduce the performance (in max SPL or self-noise) of high draw microphones such as those from Earthworks. Typically the front end filters of most live mixers are 6 or 12 dB/octave, so the 18 dB/octave filter in the cable will be more effective at cutting low frequency energy and is especially useful in applications where no external filter is available such as when sending the microphone signal into a camera. Note! The Tac!T filter is not switchable.
- 18 dB per octave
- Low-cut at 60 Hz
- Neutrik XX series male to female gold 3-pin connector
- Ultra flexible quad cable
- Pin 1 linked to shell ground
||0 dB at 1 kHz, -3 dB at 63 Hz, -40 dB at 14 Hz
||-1.5 dB (22 to 22 kHz)
|Maximum Signal Level
||+3 dBu (<0.2% distortion)
||Ultra flexible Mogami W2893 star-quad cable
||Neutrik XX series, XLR-3 male to female, black casing, gold pins
||0.19" (0.48 cm)
||18" (45 cm)
||Not specified by the manufacturer
Reviews(no ratings yet)
Give it a quick rating:
Thanks for your rating!
Write a review