DPA Microphones 4017C-R Compact Shotgun Microphone with MMP-C Preamp and Rycote Windshield Kit
Product #20640
SKU 4017C-R
Usually ships in 2 - 3 weeks


DPA Microphones 4017C-R Compact Shotgun Microphone with MMP-C Preamp and Rycote Windshield Kit

Product #20640 | SKU 4017C-R
Usually ships in 2 - 3 weeks

Used for capturing audio, provides everything needed for clear capture
Our Price $2,949.00


Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
Email me when stock arrives

The 4017C-R Compact Shotgun Microphone with MMP-C Preamp and Rycote Windshield Kit from DPA Microphones is for capturing audio. It is used in various audio for video applications such as wedding videography, film, broadcast TV, and more. This kit provides everything a boomer, outside broadcaster, journalist or location film maker could need for clear, directional sound capture. Featuring a DPA 4017C shotgun microphone pre-mounted in a Rycote suspension, with windshield, fur windjammer, XLR holder, brush, DPA XLR cable, and foam windscreen, this kit can provide maximum isolation in windy and wet weather conditions.

The 4017C-R features a supercardioid lobe-shaped directional pattern and is a pre-polarized condenser microphone. It has a frequency response of 20 Hz to 20 kHz and is powered by 48V phantom power. It is featured with the compact MMP-C pre-amp so booming applications such as in a car or in low ceiling rooms is uncomplicated. The total length of the microphone is 6.1" and it weighs only 2.5oz making it great for camera videographers. The 4017C microphone is built with an XLRM output connector. Windshield, suspension, fur windjammer, XLR holder, brush, XLR cable, and foam windscreen are included.

Key Features

  • Flexible and complete windshield and suspension package provides varying levels of wind noise attenuation
  • The suspension provides complete isolation against handling noise and cable-borne noises
  • Great for use in the field where off-axis damping is required
  • The MMP-C amplifier purposely uses a non-transformer approach to preserve sound quality while providing common mode rejection at or above 50 dB
  • Excellent RF immunity
  • Microphone super-cardioid polar pattern is highly directional

Specifications

Directional Pattern
Supercardioid, lobe-shaped
Principle of Operation
Pressure gradient, with interference tube
Cartridge Type
Pre-polarized condenser
Frequency Range
20 Hz to 20 kHz
± 2 db at 60 cm: 40 Hz to 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity
Nominal, ± 2 dB at1 kHz: 19 mV/Pa; -34 dB re. 1 V/Pa
Equivalent Noise Level
A-weighted: Typ. 13 dB (A) re. 20 µPa (max. 15 dB(A))
ITU-R BS.468-4: Typ. 24 dB (max 26 dB)
Signal to Noise Ratio
A-weighted, re. 1 kHz at 1 Pa (94 dB SPL): Typ. 81 dB (A)
Total Harmonic Distortion
< 1 % up to 137 dB SPL peak
Dynamic Range
Typ. 124 dB
Max SPL Level
Peak before clipping: 146 dB
Output Impedance
100 Ω
Minimum Load Impedance
2 kΩ
Cable Drive Capability
328' (100 m)
Common Mode Rejection Ratio
> 50 dB
Power Supply
48 V Phantom power (± 4 V)
Output Balance Principle
Impedance balancing with active drive
Current Consumption
2.8 mA
Connector
XLR-3M pin 1 shield, pin 2 signal + phase, pin 3 phase
Temperature
-40 to 113 °F (-40 to 45 °C)
Relative Humidity
Up to 90%
Output Voltage
RMS: 4.5 V
Polarity
+V at pin 2 for positive sound pressure
Dimensions (LxDiameter)
6.1 x 0.75" (154 x 19 mm)
Weight
2.5 oz (70 g)

Reviews

Own or use this product?
Give it a rating

Reviews

Own or use this product?
Give it a rating
Product:
DPA Microphones 4017C-R Compact Shotgun Microphone with MMP-C Preamp and Rycote Windshield Kit
Manufacturer:
DPA Microphones
Model:
4017C-R
SKU:
4017C-R
RM Product #:
20640