Active subwoofer for studio surround recording and mixing applications


Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
Email me when stock arrives
North Island
$29.75
South Island
$41.25

The AMBER HR subwoofer has everything on board to allow the units to be used as a Sub-Woofer for multi channel applications, plus functions and controls dedicated to use with our near fields to build a modular 3 way Monitoring system.

Balanced XLR - Input and Output connectors for 3 channels (L/C/R) are implemented, these can be used simultaneously as inputs and filtered outputs. The Filter section can be set to operate at 80Hz or 150Hz and be turned off for Surround applications. If the Sub is to be placed in a different listening distance, the relative phase can be controlled separately by dipswitches in a wide range from 0 to 360 degrees to get optimal time alignment. The value per Step is 30 degree (equal -35cm at 80Hz). Also the Input level is adjustable by dip switched from +6dB down to - 25dB.

A useful feature of the EMES Sub-Bass unit is, especially if they are used as frequency extension units for EMES's Near field monitors (MODUMO), is to bypass the filter section. The signal path than can then be monitored frequency extended (Off), or non extended (On).

Application:
Video
Broadcast
Recording
Project Studio
Mastering

Features:
320 W amplifier
Eliminates time related distortion
Controlled damping
10" Fiberglas Woofer
Dual Coil Long excursion driver
+/- 16mm membrane excursion
By-Pass function via remote
Sub-Woofer by-pass
Satellites filtered / or full range
Level and Phase control
Sensitivity adjustable and Phase

  • 40 to + 10dB

from 0 to 360 degree (12 steps)

Specifications:
System design: Dual coil long excursion bass reflex
Lower cut off frequency: 28 Hz (-3dB)
Frequency responce free field: 28 - 2.000 Hz (±3dB)
Maximum output, sine wave: 118 dB
Maximum output, long term, (RMS): 115 dB
Bass driver: 1 x 25cm fiberglas
weight: 32.2 Kg
dimensions w/h/d: 380 x 480 x 450 mm

Type of input connector: 3 x XLR, female (L/C/R)
Type of output connector: 3 x XLR, male(L/C/R)
Input Impedance: 10 kOhm
Input level adjustment: 32 steps from 0,45 - 4,5V
Low pass filter: 20 Hz / 18dB
X-Over frequency: 80 / 150 Hz
X-over by-pass / woofer mute: yes
phase polarity (degree): 0/180
phsae control (degree): 30/60/90/120/150
RMS output Bass-amp: 2x160W
distortion at acoustic max. output: 0,4%
signal to noise ration: -102 dB
kind of power supply: analog
operating voltage: 115/230 V +/- 20%
power consumtion at max. output: 340W, 25W stand by

For a full list of specifications, refer to EMES's website

Product:
EMES Amber HR Subwoofer
Manufacturer:
Emes
Model:
EME-Amber-HR
SKU:
EME-Amber-HR
RM Product #:
2264