Genelec 8020D Studio Monitor (Producer Finish)
Product #51116
SKU 8020DPM
Usually ships in 2 - 3 weeks


Genelec 8020D Studio Monitor (Producer Finish)

Product #51116 | SKU 8020DPM
Usually ships in 2 - 3 weeks

Product Features
  • 4" Woofer, ¾" Tweeter
  • 50W Bass Amplifier
  • 50W Treble Amplifier
  • Auto-Switching to Standby Saves Power
  • Class-D Amplification


Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
Email me when stock arrives

Styled in what the manufacturer has dubbed a "Producer Finish", and now utilising Class-D amplification, the Genelec 8020D Active Two-Way 4" Studio Monitor provides an accurate reproduction of the source material in a compact form factor. Its die-cast aluminium enclosure features a rounded shape, which minimises frequency and reflection distortions caused by edge diffraction. The metal dome tweeter is surrounded by Genelec's Directivity Controlled Waveguide, which helps to create an even response when listening both on and off axis.

The 8020D is built with Intelligent Signal Sensing (ISS) technology, which automatically activates the speaker when an audio signal is detected and puts it in standby mode when no signal is present, reducing its energy consumption to less than 0.5W. The 8020D features a 50W high-frequency amplifier for its ¾" tweeter, and a 50W low-frequency amplifier for its 4" woofer. The bass response is expanded by a rear-facing reflex port, and a separately available Genelec subwoofer can be used to monitor a wider array of frequencies.

Key Features

  • Attached Iso-Pod table stand insulates the speaker from vibration and enables you to tilt its position upward or downward
  • Well-suited for near-field studio monitoring, control rooms, editing suites, surround sound applications, and multimedia entertainment systems
  • Rear-facing treble-tilt, bass roll-off, and desktop cut controls enable you to optimise the speaker to its environment
  • Threaded holes for wall or ceiling brackets
  • Active crossover filter
  • Driver unit protection circuitry
  • Woofer and tweeter magnetically shielded
Cut-Off Frequency Lower: ≤ 56 Hz at -6 dB
Upper: ≥ 25 kHz at -6 dB
Frequency Response 62 Hz to 20 kHz (±2.5 dB)
SPL ≥ 100 dB SPL maximum (short-term Sinae-wave acoustic output on axis in half-space, averaged from 100 Hz to 3 kHz at 3.3' / 1 m)
93 dB SPL maximum (long-term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 3.3' / 1 m)
Peak Output Capacity ≥ 107 db maximum peak acoustic output (per pair in listening room with music material at 3.3' / 1 m)
Self-Generated Noise Level ≤ 5 dB (in free field at 3.3' / 1 m on axis (A-weighted))
Harmonic Distortion < 3% (at 85 dB SPL at 3.3' / 1 m on axis, 50 to 200 Hz)
< 0.5% (at 85 dB SPL at 3.3' / 1 m on axis, higher than 200 Hz)
Drivers Bass: 4" / 105 mm cone
Treble: ¾" / 19 mm metal dome 
Both drivers are magnetically shielded
Amplifier Bass Amplifier Short-Term Output Power: 50 W
Treble Amplifier Short-Term Output Power: 50 W
Long-term output power is limited by driver protection circuitry
THD ≤ 0.05% at nominal output
Crossover Frequency Bass/Treble: 3 kHz
Digital Controls GLM Software Frequency Response Adjustment
Parametric Notch Filters: 16x
Shelving Filters: 2 x LF and 2 x HF
System Room Response Calibration: Genelec GLM AutoCal, GLM manual, standalone
Mains Voltage 100 to 240 VAC 50/60 Hz
Power Consumption Idle: 3 W
Standby: < 0.5 W
Full Output: 60 W
Analogue Input XLR female, balanced (pin 1 ground, pin 2 positive, pin 3 negative)
Input Level -6 dBu at volume control max (for 100 dB SPL at 3.3' / 1 m)
Input Impedance 10 kOhms
Sensitivity -12 dB (constantly variable, control range relative to maximum output)
Controls Treble Tilt Control (operating range): 0 to -2 dB at 15 kHz
Desktop 200-Hz Control: -4 dB at 200 Hz
Bass Roll-Off Control: 0 to -4 dB at 65 Hz
Analogue Input Maximum Analogue Input Level: +24 dBu
Analogue Input Sensitivity: -6 dBu (100 dBSPL at 3.3' / 1 m)
Analogue Input Sensitivity Control: Adjustable from +36 to -6 dBu
Dimensions (H x W x D) 242.0 x 151.0 x 142.0 mm, Iso-Pod stand included
230.0 x 151.0 x 142.0 mm, Iso-Pod stand excluded
Weight 3.2 kg

In The Box

  • Limited 2-Year Warranty (Extendable to 5-Years Total with Registration)

Reviews

Own or use this product?
Give it a rating

In The Box

  • Limited 2-Year Warranty (Extendable to 5-Years Total with Registration)

Reviews

Own or use this product?
Give it a rating
Product:
Genelec 8020D Studio Monitor (Producer Finish)
Manufacturer:
Genelec
Model:
8020DPM
SKU:
8020DPM
RM Product #:
51116