The Eris E8 Two-Way Active 8" Studio Monitor from PreSonus delivers an accurate response with tight bass and a clear upper end. The Kevlar low frequency transducers, low-mass silk-dome tweeters and responsive Class AB amplification combine with acoustic-adjustment controls to create a versatile and adaptable listening system.
The E8 begins with a front-ported enclosure made of vinyl-laminated MDF. It features an 8" Kevlar low-frequency woofer driven by a 75W, Class AB amplifier. For the highs, Eris employs a 1.25" silk-dome tweeter powered by a 65W, Class AB amplifier. The E8 outputs a clean 105 dB peak SPL. Its frequency response is rated at 35Hz to 22kHz.
The Eris E8 provides a balanced XLR, a balanced ¼" TRS, and an unbalanced RCA line-level input. Once you're plugged in, set the Input Gain and you're ready to go!
Acoustic Tuning Controls
The Eris provides three AEQ controls in its Acoustic Tuning section: High, Mid, and Low Cutoff. These controls enable you to fine-tune the monitors to your space. The Low control also is useful when using the E8 with a subwoofer.
The High control is a shelving filter that boosts or cuts all frequencies above 4.5kHz by as much as 6dB. The Mid control is a mid-frequency peak filter that boosts or cuts frequencies centred at 1kHz and extending about one octave above and below that frequency. The Low Cutoff control rolls off frequencies below either 80 or 100Hz at a slope of 12dB/octave. This control is especially useful if you also have a connected subwoofer.
Acoustic Space Control
A three-position Acoustic Space switch controls a second-order, low shelving filter that cuts frequencies below 800 Hz by either 2 or 4dB to compensate for the boundary bass boost that occurs in close proximity to walls or corners.
Thorough Protection Circuitry
RF shielding protects against radio frequencies that could be introduced to the signal and become audible. Eris monitors also provide overheat protection, current-output limiting and subsonic protection. "Soft startup" amplifiers prevent damaging pops from sounding through the speakers when you power them up.
|Inputs||1 x XLR balanced|
1 x 1/4" TRS balanced
1 x RCA phono unbalanced
|Frequency Response||35 Hz to 22 kHz|
|Crossover Frequency||2.2 kHz|
|Maximum SPL||105 dB @ 1 metre|
|Low Frequency Driver||8" (10.32 cm) Kevlar|
|High Frequency Driver||1.25" (3.18 cm) silk dome|
|Volume Control||A-type taper|
|Equalisation||HF Control: -6, 0, +6 dB; continuously variable|
MF Control: -6, 0, +6 dB; continuously variable
Low Cut Filter: Flat, 80 Hz, 100 Hz; switchable
Acoustic Space Control: Flat, -2 dB, -4 dB; switchable
External mains fuse
|Enclosure Material||Vinyl-laminated MDF|
|Power Requirements||100 to 120V or 220 to 240V, 50/60 Hz|
|Dimensions (W x D x H)||250 x 299 x 384 mm|