Product Features
  • 3 / 50 / 220 Lumen Outputs
  • White Cree XP-E2 (R3) LED
  • Emergency SOS Signal Mode
  • Two-Stage Pushbutton Tailcap Switch
  • Momentary and Constant-On Activation

Need more information about this product? - We'll get back to you ASAP
You must enter a valid email address.
Email me when stock arrives
North Island
South Island

Designed to be versatile enough for use at home, on the trail, or on-duty, Fenix 's LD09 LED Flashlight has been upgraded over previous iterations to be a more powerful illumination tool that still fits comfortably in the palm of your hand. Its 3-lumen low output is ideal for tasks like reading, while the 220-lumen high setting will light a trail or large area. If you use one AA alkaline battery instead of a 14500 Li-ion, all outputs remain the same but with different runtimes, and a lower turbo output of 130 lumens. An emergency SOS signal mode, when activated, automatically cycles through the Morse code sequence so you don't have to if you're incapacitated.

To stand up to a long life in the field, the LD09's aluminium housing features a corrosion and scratch-resistant type III hard anodised finish. It is impact resistant to 1.0 m and O-ring sealed to give it an IPX8-rating to be submersible to 2.0 m. The emitter window is made of impact and scratch resistant glass with anti-reflection coatings to maximise light transmission. Multiple safety circuitries are in-place to protect the light from damage caused by incorrectly installed batteries or excessive heat. Additional circuitry detects the battery chemistry being used and adjusts the performance accordingly to maximise the battery life while digitally maintaining the output to provide a consistent beam intensity throughout the life of the battery charge.

Key Features


  • Low: 3 lumen
  • Moed: 50 lumen
  • High: 220 lumen (with 14500 battery) or 130 lumen (with AA battery)
  • White Cree XP-E2 (R3) LED
  • SOS distress signal automatically cycles through Morse code sequence
  • Reflector produces a smooth beam with bright centre cone and dimmer peripheral ring


  • Type: 2-stage pushbutton
  • Location: tailcap
  • Momentary and constant-on modes
  • All beam intensities and SOS signal mode accessible by using pushbutton switch
  • Partially shrouded tailcap switch helps to prevent accidental activation


  • Lightweight and durable aluminium housing
  • Type III corrosion and scratch-resistant hard anodised finish
  • IPX8-rated submersible to 2.0 m for up to 30 minutes
  • Impact resistant to 1.0 m
  • Scratch and impact-resistant tempered and anti-reflection coated glass window
  • Anti-roll collar helps to keep light from moving or shifting position


  • Runs on one AA alkaline (included), AA Ni-MH or 14500 Li-ion battery
  • Intelligent drive circuitry automatically detects battery type installed and adjusts to maximise performance
  • Digitally regulated output maintains consistent intensity throughout life of battery
  • Reverse polarity protection prevents damage due to improper battery installation
  • Overheat protection automatically steps-down output to prevent damage to circuitry
Illumination Source1 x White Cree XP-E2 (R3)
Output RangeAA battery:
Low: 3 lumen
Moed: 50 lumen
High: 130 lumen

14500 battery:
Low: 3 lumen
Moed: 50 lumen
High: 220 lumen
Battery1 x AA, alkaline or Ni-MH
1 x 14500 Li-ion
RuntimeAA alkaline battery:
Low: 43.0 h
Moed: 5.0 h
High: 0.8 h

14500 battery:
Low: 58.0 h
Moed: 8.25 h
High: 1.0 h
ConstructionAluminium alloy
WaterproofingIPX8-rated, waterproof and submersible to 2.0 m
Impact Resistance1.0 m
Dimensions3.7 x 0.75" / 9.4 x 1.9 cm
Weight35.0 g, without battery
Fenix Flashlight LD09 LED Flashlight (11/2015 Edition)
RM Product #: