RCF Active 2-Way Array Speaker System

Description

The RCF Active 2-Way Array Speaker System is equipped with three 10" neodymium woofers and a 1.4" compression driver with a 3" voice coil on an asymmetrical waveguide. The system accepts female XLR input connectors and line level signals from a mixing console or other signal source, while the output XLR male connector provides a loop-through for daisy-chaining speakers. The Mic/Line switch is used to adjust the input sensitivity. When used just for speech, the Mic setting allows you to use a microphone directly with the speaker. You can set the selector to Line when using the speaker for live music or playback.

Key Features:

Status Indicators

• Power indicator: When the power cord is connected and the power switch is turned on this indicator lights green.
• Signal indicator: Lights green if there is signal present on the main XLR input.
• Limiter indicator: The amplifier has a built-in limiter circuit to prevent clipping of the amplifiers or overdriving the transducers. When the peak clipping circuit is active the LED blinks orange.
• RMS limiter: Prevents damages to the transducers. If the RMS limiter is active the LED lights red.

Other Features

• Powered by a 1400W peak power digital amplifier (split 400W for high frequency and 1000W for low frequency)
• 3 x 10" neodymium mid-bass drivers, 2.5" voice coil combined with a fibreglass former
• Precision controlled by an on-board DSP-driven controllers
• M-roll surround shape
• Edge wound voice coils
• ND 840 compression driver with 3" diaphragm with a 1.4" exit throat; asymmetrical horn for optimised coverage
• AEQ switch
• PowerCON locking 3-pole AC mains
• Volume knob controls the volume of the power amplifier
• AC PowerCON link receptacle to link one or more units
• Power switch turns the AC power on and off
• Provides two-way line source

Applications

• Portable PA
• Live sound
• Performance venues
• Houses of worship
• Live clubs