Varavon Slidecam LITE 1200 Camera Slider

Description

The Varavon Slidecam LITE 1200 Camera Slider is approximately four feet long and features three steel bearing rollers. The slider track incorporates two sets of 1/4"-20 and 3/8"-16 mounting holes, allowing you to support it at both ends. Two removable height adjustable legs are also included for using the slider on the ground. The legs provide height adjustment for levelling, and are articulated, allowing you to adjust them for uneven surfaces.

The slider weighs just under four pounds and supports up to 9 kg of weight. The slider carriage features a 3/8"-16 threaded mounting screw with a large thumb wheel to tighten down available flat base heads. It features a friction break mechanism that can apply tension or lock the carriage in place along the rails. The carriage incorporates a built-in bubble level that allows you to confirm the level of the track. The included oil seal is used to clean and oil the chrome plated track for smooth sliding. Included with the slider is a focus sling and a carry case for transport or storage.

Features

• The slider platform rides on three wheels with sealed bearings, and it is captive in the track bed. This allows you to flip the track over and get that inverted shot without worrying that the carriage will fall off the tracks.
• Chrome coated rails are rust and corrosion resistant.
• The feet are removable and attach to the track using a large easy to use spin wheel.
• The removable feet feature a single point of articulation, providing 90° of vertical adjustment.
• The built-in end stops feature threaded holes that allow you to mount available accessories.
• Included with the slider and carriage is a focus sling that you wrap around your lens. This provides you with a lever for pulling focus on your slider setup.