The CAD M-179 Studio Condenser Microphone is a side address studio condenser microphone that provides the flexibility to handle any recording scenario while remaining cost effective. At the heart of the M-179 is a dual pattern version of the diaphragm found in the Equitek E-300. The 1.1" diaphragm yields a high SPL rating and a wide 10Hz to 20kHz frequency response. A variable pattern control dial allows users to select cardioid, omni-directional and figure 8 polar patterns. A 20dB Pad switch is used to provide higher headroom resulting in 143dB SPL. A high-pass filter switch eliminates noise and rumble below 100Hz. In addition to its rugged design, a stainless steel internal pop/EMI filter reduces noised do to plosive wind noise and sibilance. The microphone requires 24V or 48V phantom power.
Key Features
E-300 Capsule
- The M-179 utilizes a dual pattern version of the Equitek E-300 capsule. The 1.1" gold sputtered diaphragm yields a 10Hz to 20kHz frequency response.
Variable Pattern
- A variable pattern dial offers variations of cardioid, omni-directional and figure 8 polar patterns.
20dB Pad Switch
- A 20dB Pad switch provides additional headroom and an SPL rating of 143dB.
High-Pass Filter
- A user switchable high-pass filter eliminates noise and rumble below 100Hz.
Specifications
| Transducer |
Side Address, External bias condenser |
| Polar Pattern |
Variable: Cardioid, Omni-directional, Figure 8 |
| Frequency Response |
10Hz to 20kHz |
| Dynamic Range (Typical) |
133 dB |
| Signal-to-Noise Ratio |
Equivalent Noise Level: 11dB Equivalent SPL, A weighted |
| Maximum Input Sound Level |
143 dB SPL (With pad on) |
| Power Requirements |
Minimum Requirements are 24, 48 Volt Phantom Power capable of delivering at least 8 mA |
| Output Impedance |
Low (200 ohms nominal) |
| Output Connectors |
3-pin XLR-male |
| Pad |
20dB |
| Low Frequency Roll-Off |
80Hz |
| Dimensions |
7 x 2.25" (177.8 x 57.2mm) (Length x Diameter) |
| Weight |
17.8 oz (506 g) |
