The Kingston 8GB HyperX FURY DDR3 1600 MHz DIMM Memory Kit comes with two 4GB memory modules to deliver a total memory capacity of 8GB for your desktop computer. The DDR3 modules are compatible with systems that have 240-pin slots. For performance, each module has been tested to run up to 1600 MHz at a latency timing of 10-10-10 under 1.5V. Moreover, Kingston has designed the pair of memory modules to operate at 1333 MHz or 1066 MHz for compatibility with older motherboards. They sport eight 512M x 8-bit DDR3 FBGA components per module. Furthermore, Kingston has armed each memory module with a black heatsink to cool the components.
Features
PnP JEDEC Timing Parameters
The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. The maximum speed will be determined by the computer's BIOS.
- DDR3-1600 CL10-10-10 @ 1.5V
- DDR3-1333 CL9-9-9 @ 1.5V
- DDR3-1066 CL7-7-7 @ 1.5V
General Features
- JEDEC standard 1.5V (1.425 to 1.575V) power supply
- VDDQ = 1.5V (1.425 to 1.575V)
- 800 MHz fCK for 1600 Mb/sec per pin
- 8 independent internal banks
- Programmable Additive Latency: 0, CL-2, or CL-1 clock
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS)
- Bi-directional differential data strobe
- Internal self-calibration through ZQ pin (RZQ: 240 Ohms ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period: 7.8 µs at lower than TCASE 185°F; 3.9 µs at 185°F < TCASE = 203°F
- Asynchronous reset
- Height 1.291" (32.8 mm) with heatsink, single-sided component
Specifications
| Capacity | 8 GB |
| Kit Configuration | 2 x 4 GB |
| Speed | PC3-12800 (1600 MHz) |
| Memory Type | DDR3 |
| DIMM Type | 240-Pin DIMM |
| Buffered/Registered | No |
| Error Correction (ECC) | Non-ECC |
| Voltage | 1.5 V |
| CAS Latency | CL10 |
| Memory Rank | Single Rank |
