| Inputs (Analogue) |
2 x 6-pin block connectors |
| Outputs (Analogue) |
2 x 3-pin block connectors |
| Dante Connection |
1 x RJ45
Channel Count: 2 inputs, 2 outputs |
| Polarity |
Non-inverting, any input to any output |
| Power Requirements |
Power over Ethernet (PoE), Class 0 (PoE Plus compatible) |
| Power Consumption |
11 W maximum |
| Application Control |
HTML5 |
| Operating Temperature Range |
20 to 104°F (-6.7 to 40°C) |
| Storage Temperature Range |
20 to 165°F (-29 to 74°C) |
| Thermal Dissipation |
Maximum: 12.1 W (41.3 BTU/hr)
Typical: 9.8 W (33.7 BTU/hr) |
| Audio |
|
| Frequency Response |
20 Hz to 20 kHz ±1 dB |
| Dante Audio Flows |
Sampling Rate: 24-bit/48 kHz |
| Latency |
Does not include Dante latency
Analogue to Dante: 0.35 ms
Dante to Analogue: 0.71 ms |
| Analogue Gain Range |
51 dB (adjustable in 3 dB steps) |
| Dynamic Range |
113 dB, 20 Hz to 20 kHz, A-weighted, typical |
| Equivalent Input Noise |
20 Hz to 20 kHz, A-weighted, input terminated with 150 Ohms
Analogue Gain Setting = +0 dB, -93 dBV
Analogue Gain Setting = +27 dB, -119 dBV
Analogue Gain Settings = +51 dB, -130 dBV |
| Total Harmonic Distortion (THD) |
<0.05% @ 1 kHz, 0 dBV input, 0 dB analogue gain |
| Common Mode Rejection Ratio |
>70 dB, 50 Ohms balanced source @ 1 kHz |
| Input Impedance |
5 kOhms |
| Output Impedance |
150 Ohms |
| Input Clipping Level |
Analogue Gain Setting = +0 dB, +20 dBV
Analogue Gain Setting = +27 dB, -7 dBV
Analogue Gain Setting = +51 dB, -31 dBV |
| Analogue Output Levels |
Selectable Line 0 dB
Aux -20 dB
Mic -46 dB |
| Digital Signal Processing (DSP) |
Per Channel: Equaliser (4-band Parametric, Dante channels only), Mute, Limiter, Gain (140 dB range)
System: Channel Summing |
| Networking |
Cat 5e or higher (shielded cable recommended) |
| Dimensions (H x W x D) |
1.6 x 5.5 x 5.0" (4 x 14 x 12.8 cm) |
| Weight |
1.5 lb (672 g) |
