JBL Control 60PS/T Pendant Subwoofer with Crossover (White)

Product #64883 | SKU CONTROL60PST-WH | JBL
This product is no longer available what does this mean?
Not currently for sale
Contact us for more information
This product is no longer available what does this mean?

Overview

Features low distortion 150W power handling, an 8" low frequency driver, a high-temperature 2" voice coil and low-mass fiber glass coil.

Description

The white JBL Control 60PS/T Pendant Subwoofer with Crossover (White) is a pair of subwoofers featuring low distortion 150W power handling, and an 8" low frequency driver with a butyl rubber surround for well-damped, tight sound quality and long-term reliability, with a polypropylene-coated cone for humidity protection. The high-temperature 2" voice coil and low-mass fibreglass coil former ensure good bass transient response and stability under high power, high duty-cycle working conditions. The Control 60PS/T provides bass extension and high impact for high-fidelity sound systems in a wide variety of applications.

The Control 60PS/T may be driven by itself, or with other subwoofers, on an amplifier channel, sending it either a signal that has been actively low-passed earlier in the signal chain via DSP or a full-range signal, utilising the built-in passive 125 Hz low-pass filter. The included passive crossover also provides high-passed satellite outputs for use with either two or four satellite loudspeakers (not for one or three satellite speakers), resulting in a full-range, wide-bandwidth, passively-crossed, mono subwoofer-satellite system. Using the built-in passive crossover is best suited for satellite speakers with sensitivities in the 82 dB to 86 dB (2.83V @ 1m) range, resulting in a well-balanced overall frequency response.

A 100W multi-tap, wide-bandwidth, low-saturation transformer allows the speaker to be used on either a 70V/100V distributed speaker system, or as a direct low-impedance 8 ohms speaker. If satellite speakers are used on the 70V/100V settings, the satellite speakers should be low-impedance (8 - 16 ohms each). A loop out connector is provided on the subwoofer for looping the full-range input signal to other loudspeakers or to other subwoofer/satellite systems. Rubber boot covers for each locking connector protect the terminals when using the speaker outdoors.

Key Features:

  • High-impact, 150W direct radiating subwoofer with built-in crossover for up to four satellite speakers
  • 8" Long-excursion driver and 2" voice coil
  • 8 ohms and 150 W, or 70-100V and 100 W operation
  • Hanging hardware with 15' galvanised steel cable, spring-clips for clipping onto loudspeaker, and Gripple-brand adjustable-height cable fasteners
  • Speaker and hanging cable system are UL listed

Specifications

Frequency Range 42 - 350 Hz @ -10 dB
Frequency Response 55 - 125 Hz @ ±3 dB
Nominal Sensitivity 88 dB, 2.83 V / 1 m
Maximum SPL Average: 107 dB @ 3.3' (1 m)
Peak: 113 dB
Rated Impedance 8 ohms
Transformer Taps 110 W, 55 W, 30 W (and 15 W @ 70 V)
Transformer Insertion Loss 0.98 dB @ 15 W
0.99 dB @ 30 W
0.94 dB @ 55 W
1.10 dB @ 110 W
Connectors 2 x 2-pin Euroblock terminal, input
2 x 2-pin Euroblock terminal, input loop-out output
2 x 2-pin Euroblock terminal, satellite hookup
Transducer 8" (200 mm) driver
2" (50 mm) voice coil
Suspension 15' (4.5 m) long, 0.2 cm (2 mm) high-tensile galvanised steel wire rope
Suspension Support 99 lb (45 kg), SWL rating
Power Capacity Continuous Programme Power: 300 W, 100 hours
Continuous Pink Noise: 150 W, 100 hours
Material Enclosure: High impact polystyrene
Driver: Polypropylene-coated paper cone with butyl rubber surround
Voice-coil: High-temperature copper, vented fibreglass resin voice coil former
Grille Zinc-plated steel grille with powder-coat finish, foam backing
Grille and grille backing are removable for painting
Environmental Exceeds Mil Spec 810 for humidity, salt spray, temperature & UV
IP44 capability per IEC 529 - splash-proof rating
Compliance IEC60849/EN60849
Speaker: UL1480 (UEAY)
Transformer: UL1876
Suspension System: UL1598 & UL2239, TUV, CSA Class 3426-01 & Class 3426-81
Cable Fasteners: UL1598 & UL2239, TUV, CSA Class 3426-01 & Class 3426-81
Dimensions To top of cabinet: 13.1 x 13.5" (333 x 344 mm)
To top of suspension bracket: 13.1 x 14.5" (333 x 369 mm)
Weight 16.8 lb (7.6 kg)

In The Box

  • JBL Control 60PS/T Pendant Subwoofer with Crossover (White).
  • Suspension Cable Systems.
  • Locking 2-Pin Euroblock Connectors.
  • Rubber Cover Boots for Euroblock Connectors.

Reviews

0.0 (no ratings yet)
Own or use this product?
Give it a quick rating:
Thanks for your rating!
Share your thoughts with other customers:
Write a review

Details

  • Product: JBL Control 60PS/T Pendant Subwoofer with Crossover (White)
  • Manufacturer: JBL
  • Model: CONTROL60PST-WH
  • SKU: CONTROL60PST-WH
  • RM Product #: 64883

Recently Viewed

View All