Rolls PM57 Headphone Tap with Attenuation Switch has been discontinued, here are some related products you might like:
Rolls PM57 Headphone Tap with Attenuation Switch
Features
- No External Power Required
- Lowers Speaker Level to Headphone Level
- 3-Way Attenuation Switch
- On-Board Volume Knob
- Power Amp Loop-Through in Stereo or Mono
Description
The PM57 from Rolls is a headphone tap with an on-board attenuation switch. A passive unit requiring no external power supply, this device will allow you to convert speaker-level signals to audio suitable for headphones. As such, you can use the PM57 to eliminate the necessity of ungainly wedges or speaker monitors. Simply loop in your power amp through its input, attenuate the signal as needed via the switch, connect your headphones, adjust the volume pot, and you're good to go.
A couple of other features worth noting: The PM57 boasts 1/4" inputs as well as a wired screw-terminal connection. The 1/4" jacks can accept both TRS stereo and TS mono termination points, and a mono/stereo switch will affect the signal of both sets of connections. Also, you can use stereo 1/4" and 3.5 mm headphones with this device.
Features
- No external power or batteries required
- Power amp loop-through
- Mono/Stereo mode
- Converts speaker level signals to headphone level
- Attenuation switch to match proper input level
- Will monitor 25, 70, and 100 V lines
Specifications
Attenuation Switch | Adjusts for greater than/less than 50 W |
Input Impedance | 150 Ohms |
Connections | 1 x wired screw-terminal input 1 x TRS/TS power amp input 1 x TRS/TS power amp output 1 x 1/4" headphone output 1 x 3.5 mm headphone output |
Dimensions | 2.8 x 3.0 x 1.3" / 7.0 x 7.6 x 3.2 cm |
Weight | 0.2 kg |
In The Box
- Rolls PM57 Headphone Tap with Attenuation Switch
Reviews
(no ratings yet)Give it a quick rating:
Thanks for your rating!
Write a review
Details
- Product: Rolls PM57 Headphone Tap with Attenuation Switch
- Manufacturer: Rolls
- Model: PM57
- SKU: PM57
- RM Product #: 39110